Wakeboarder Forum Index

 
 FAQFAQ   SearchSearch   MemberlistMemberlist   StatisticsStats   FavoritesFavorites   RegisterRegister   ProfileProfile   Log in to check your private messagesLog in to check your private messages  Log inLog in 
BlogsBlogs   

Finding RPM lead when using smartcraft gages.

 
Post new topic   Reply to topic    Wakeboarder Forum Index -> Wakeboard Boat General Discussion
View previous topic :: View next topic  
Author Message
jryan15
Newbie
Newbie


Joined: 20 Jul 2008
Posts: 23

PostPosted: Jul 21, 2008 7:27 pm    Post subject: Finding RPM lead when using smartcraft gages. Reply with quote

I've been thinking of added a perfect pass system to my 2004 sea ray which has smartcraft gages. I was wondering if anyone could tell me where I can get a tach feed off of the gages or engine with this setup. The engine looks to have an electronic ignition system. The engine is the 5.0L model.

Thanks!
Back to top
View user's profile Send private message
JUST-IN-TIME
Soul Rider
Soul Rider


Joined: 24 Dec 2007
Posts: 356
City: ON YOUR BOAT

PostPosted: Jul 23, 2008 12:23 pm    Post subject: Reply with quote

grey wire is the tach readout
comes off the ecu
u have tbolt v ignition

_________________
HUMAN BUILT = HUMAN FIXED
CERTIFIED MARINE/PWC TECHNICIAN
www.switchbait.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
jryan15
Newbie
Newbie


Joined: 20 Jul 2008
Posts: 23

PostPosted: Aug 23, 2008 7:29 pm    Post subject: Reply with quote

Thanks for the advice, but I didn't get the RPM readout to work on the perfect pass unit. I found a gray wire in one (left side) of the two connectors that plugged into a module on top of the engine. I assume that was the ECU...

The perfect pass RPM cable has a black and gray lead. I connected the gray to the gray wire at the engine and I just tied the black to the grounding block under the dash. I was wondering if maybe I need to connect to a direct ground lead off of the ECU itself...
Back to top
View user's profile Send private message
JUST-IN-TIME
Soul Rider
Soul Rider


Joined: 24 Dec 2007
Posts: 356
City: ON YOUR BOAT

PostPosted: Aug 23, 2008 7:37 pm    Post subject: Reply with quote

what colors are coming off the dash tach???

i have all the manuals for the smartcraft stuff

_________________
HUMAN BUILT = HUMAN FIXED
CERTIFIED MARINE/PWC TECHNICIAN
www.switchbait.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
jryan15
Newbie
Newbie


Joined: 20 Jul 2008
Posts: 23

PostPosted: Aug 24, 2008 6:42 am    Post subject: Reply with quote

Thanks. All my gages are daisy chain connected with the same three wires red, yellow, blue...

My distributer cap is not the normal round style, it's flat with the spark plug connectors coming out of the sides. The is a coil has a three pin connector going to it with the following wires.

1. Pink with white stripe
2. White with green stripe
3. White with green stripe (again)

I would imagine that one of them is a tach lead, but I don't want to go stabbing at them without knowing more.

Also the flat distributer also has a three pin connector coming off of it. There is nothing plugged into it. I guess it was for systems with an integrated coil or something...
Back to top
View user's profile Send private message
jryan15
Newbie
Newbie


Joined: 20 Jul 2008
Posts: 23

PostPosted: Aug 24, 2008 10:53 am    Post subject: Reply with quote

Got it working! The tach is working after connecting to the middle white with green striped wire that I mentioned in the earlier post...
Back to top
View user's profile Send private message
JUST-IN-TIME
Soul Rider
Soul Rider


Joined: 24 Dec 2007
Posts: 356
City: ON YOUR BOAT

PostPosted: Aug 24, 2008 3:57 pm    Post subject: Reply with quote

cool

merc changed a bunch of tings around since going smartcraft

_________________
HUMAN BUILT = HUMAN FIXED
CERTIFIED MARINE/PWC TECHNICIAN
www.switchbait.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    Wakeboarder Forum Index -> Wakeboard Boat General Discussion All times are GMT - 8 Hours
Page 1 of 1

Add To Favorites

Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
             


Copyright © 2012 - Wakeboarding - Wakeboarder.com - All Right Reserved
Powered by phpBB © 2001, 2005 phpBB Group