Removable SLider, HELP!!

[napeterson]

Does anyone have any good ideas for a removable slider that can be put up and taken down in minutes.... I need to figure somethin out, and quick.

Thanks yall

[Liquid*Force*Rider]

ya man,

ok
1. put a 4x4 into the ground like you are building a permenet slider (DON"T DO untill you are at step #
2.powned them into the ground 2-3 feet and put the side arm on (DON"T DO untill you are at step #
3. about 1 foot above the side arm cut the wood(4x4)
4.take door hindges 2 for each post screw them on the 4x4 with the circle part where the pin goes through facing to the surface of the water
5. Build the slider (the part that will be out of the water)
6. make sure the posts (4x4) going down line up with the other 4x4's that go out of the water
7. when you are done building the top(part that is out of the water) attached the 4x4's to the top of your slider
8. dive under and powned the 4x4 like #1
9. When the whole slider is built and the 4x4's in the ground are pownded take the top of the slider....
10.... line the 4x4's up and dive under and put the pins (that came with the door hinges) through the hinge on all of 4x4's so that all the 4x4's are like one solid 4x4
11. Taking down dive under pull out all the pin on the hinges and the slider will come off and the slider will go together in about 10

HOPE THIS HELP YOU

|
1. ~~~~~~|~~~~~~~~
|


|
2. ~~~~~~|\~~~~~~~~
|


3. cut the wood off here>>
|
~~~~~~~~~~~~~~~~|\~~~~~~~~~
|


4. screw the door hindages on here >> << facing up
|
~~~~~~~~~~~~~~~~~~~|\~~~~~~~~~~~~~
|


5. /TTTTTTTTTT\


8. Look at #1






[b[10.[/b] this is what you will get




/TTTTTTTTTT\
~~~~ | | | | | | | |~~~~~~~~~~~~~~~~~~



Have Fun with it

[Liquid*Force*Rider]

sorri man the little picture didn't work to will

[napeterson]

im gonna try that out, thanks alot, you the MAN

[ben]

why do you need to take it out?

[napeterson]

because the lakes in MN are gay like that

[simland]

hahaha, yea... they are