Stereo issues Wet sounds connectors

Bambamski · Posted: Jun 06, 2011 9:04 am Post subject: Stereo issues Wet sounds connectors

Well after some good weekends behind my two buddies X-stars I finally got my boat out for it's first run of the year. Still taking on water which isn't good. I need to take a hard look at the ballast to see if that's where I'm leaking water.

My question is the stereo. Just sitting on the water or the drive way the tower speakers were fine to a cerntain audio level. If I turn it up too loud the speakers cut out. When I'm moving the speakers cut out as well. When I turn the stereo off and then on they'll start back up? Where should I start looking? All my connections?

Ok and my question for the Wet sounds guys. I have the quick connectors. The wired pulled out of it over the winter and I tried putting it back in. There are four spots where you can put the wire into the connector (little holes). I think my stereo guy just put them into one of the little holes. So I did that and I'm not getting any sound at all. How do you wire those connectors? Did that make sense? if it didn't I'll get some pictures in the next couple of days.

PimpinD2 · Posted: Jun 06, 2011 11:45 am Post subject:

http://www.wetsounds.com/media/products/manuals/Wet_Sounds_PRO485_User_Manual.pdf

has a diagram of hooking up the connector. It unscrews.

Bambamski · Posted: Jun 07, 2011 12:09 pm Post subject:

pimpin thanks. That will solve the connector. I'm not sure about the cutting out though...

PimpinD2 · Posted: Jun 07, 2011 12:23 pm Post subject:

give it a whirl.. it it was a bad connection it could be...