|
|
|
View previous topic :: View next topic |
Author |
Message |
Enygma Soul Rider
Joined: 26 Jul 2009 Posts: 356
|
Posted: Jul 01, 2010 8:39 pm Post subject: BIG electrical problems, help! |
|
|
SO today I'm out on some glass water and giving my buddy a pull then the whole boat just shuts down. just boom, no power to anything but the trim motor which is ran seperately straight off the battery.
We checked EVERYTHING. The only bad thing we found was a single wire being chewed through by the pulley system. This wire goes from the battery, to a little black box ...really little, to a big blue thing, to the alternator. we're about 99% sure this is for charging purposes and see no reason why this would stop all power everywhere.
All fuses on the panel up front look good and we didn't find any in line fuses in the back or on the way there. I am seriously stumped...
Also another shitty part of this story, After seeing that wire had been cut through and we tied it back together there was still no power. So I went back to the starter and found that the power wires were very loose, easy to wiggle. The stud coming off the solenoid broke when I went to tighten it:( I can't rebuild the solenoid myself as its a completely sealed unit(already tried) We've replaced the starter once already at a cost of $380 and I would HATE to spend $380 just because of a broken stud...any ideas?
Very BAD Canada day for me:( no pull on butter lake, boat broke down and broke the starter. I should have just stayed in bed this morning.
Oh yeah, the boat is a 97 glascon 180 ultra. . |
|
Back to top |
|
|
|
Enygma Soul Rider
Joined: 26 Jul 2009 Posts: 356
|
Posted: Jul 02, 2010 8:30 pm Post subject: |
|
|
Update: we figure out a way to make the starter work with the broken stud. Simply tied the 3 cables(2 8 gauge, 1 10 gauge) coming to it into 1 4 gauge cable(just bolted the terminals together) and bolted the 4 gauge cable to the starter. There was JUST enough of the stud left to get a good grab on the nut with 1 terminal on there.
Now that that's all back together and I have access to a test light I can start looking for where the power stops going through. |
|
Back to top |
|
|
|
|
Add To Favorites
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum
|
Copyright © 2012 - Wakeboarding - Wakeboarder.com - All Right Reserved
Powered by phpBB © 2001, 2005 phpBB Group
|
|
|