| View previous topic :: View next topic |
| Author |
Message |
critterCQB Criminal

Joined: 10 Dec 2007 Posts: 58 City: Neptune Beach
|
Posted: Jul 21, 2008 8:48 am Post subject: Low Oil Pressure! |
|
|
Wasn't sure what section to post this under.
We were out all day Saturday, and all was fine. On the way back to the marina, I looked down and was at like 5-8 psi. We made it back to the marina fine, no noises, smells, explosions(ha!), etc...
Sunday, I fired it up at my work to flush it out. I checked the guage, and I was back to 40 psi, nice! 15 minutes later, i was at 5-8 psi again(sh*t).
Oil level is right where it needs to be, no oil in the bilge either. Any clues?
Oh, it's an '86 Comp, PCM 350. _________________
 |
|
| Back to top |
|
 |
|
|
vawakemonster Wakeboarder.Commie


Joined: 03 Sep 2004 Posts: 1285 City: fredericksburg
|
Posted: Jul 21, 2008 9:04 am Post subject: |
|
|
bad oil sensor?
if the exhaust Smokey? _________________ R.I.P. M. Legge
| K-dub wrote: | | ......hell, even borrowing your mom's lotion and rubbing one out would be a good idea to pass some time. |
|
|
| Back to top |
|
 |
JUST-IN-TIME Soul Rider

Joined: 24 Dec 2007 Posts: 356 City: ON YOUR BOAT
|
Posted: Jul 21, 2008 1:06 pm Post subject: |
|
|
well E-Z to test the gauge and sensor
find the sensor
pull the wire off of it
ground it out
the gauge with key on should read full/high pressure, if not bad gauge
when was the last oil change?
and if the oil is all the way to the top of the marks, u r over full _________________ HUMAN BUILT = HUMAN FIXED
CERTIFIED MARINE/PWC TECHNICIAN
www.switchbait.com |
|
| Back to top |
|
 |
DRAGON88 Ladies Man


Joined: 12 Jan 2003 Posts: 8213 City: Portland, OR
|
Posted: Jul 21, 2008 4:22 pm Post subject: |
|
|
critterCQB, First thing would be to get a mechanical oil pressure gauge and make sure you're actually getting oil pressure.
Due to the nature of the symptoms I would guess a bad gauge could the the culprit. But it could also be something more serious, you definitely want to confirm that you have oil pressure as the first matter of business.
While it is true that oil thins out through its life cycle, it doesn't explain why the oil pressure is surging... _________________ wakeboards
wakeboarding |
|
| Back to top |
|
 |
critterCQB Criminal

Joined: 10 Dec 2007 Posts: 58 City: Neptune Beach
|
Posted: Jul 22, 2008 8:18 am Post subject: |
|
|
No smokey exhaust, smells fine too. Last oil change was spring of this year. Puzzling. Where can I find a mechanical oil pressure guage? _________________
 |
|
| Back to top |
|
 |
pet575 Wakeboarder.com Freak


Joined: 20 Jun 2006 Posts: 3630 City: Kansas City, MO
|
Posted: Jul 22, 2008 10:32 am Post subject: |
|
|
If you get no answers after these tests, verify that you did not combine regular motor oil with a synthetic. This can cause low oil pressure at low RPMs. You don't say whether it is at all RPMs or just certain ones. _________________
| Wakebrad wrote: | | I honestly think it has to do with internet penetration... |
|
|
| Back to top |
|
 |
JUST-IN-TIME Soul Rider

Joined: 24 Dec 2007 Posts: 356 City: ON YOUR BOAT
|
Posted: Jul 22, 2008 10:58 am Post subject: |
|
|
any auto store for a gauge _________________ HUMAN BUILT = HUMAN FIXED
CERTIFIED MARINE/PWC TECHNICIAN
www.switchbait.com |
|
| Back to top |
|
 |
brotherbrown831 Outlaw

Joined: 26 May 2008 Posts: 154 City: Oklahoma City
|
Posted: Jul 22, 2008 5:05 pm Post subject: |
|
|
1986' 350, well its completely possible that you have some bearing wear and your oil pressure is low at low RPM becuase your engine bearings are getting loose. This is natural over time but things like, over reving, over heating, improper warm up will all contribute to early bearing failure. If you find that the guage is correct and you oil pressure is that low, I would drain your oil and inspect for small shiny metal shavings or powder in the oil. If the metal shavings are not to bad switch to a heavier weight oil and it will extend the life of your engine a while.
Good news though, if you have to rebuild your engine its the easiest engine you could hope to rebuild. _________________ Lets see how many cliche inspirational sayings we can throw at the rider in one pull, they really do help... |
|
| Back to top |
|
 |
critterCQB Criminal

Joined: 10 Dec 2007 Posts: 58 City: Neptune Beach
|
Posted: Aug 08, 2008 5:55 pm Post subject: |
|
|
I went out and bought a manual oil pressure gauge. $18, not bad at all. Located the sending unit, and it had oil running out of the top! Removed the sending unit, screwed the new gauge in, fired her up, 38 PSI! We're good to go! So now it's looking like a new sending unit, or permanently install the manual gauge... we'll see. _________________
 |
|
| Back to top |
|
 |
JUST-IN-TIME Soul Rider

Joined: 24 Dec 2007 Posts: 356 City: ON YOUR BOAT
|
Posted: Aug 11, 2008 1:24 pm Post subject: |
|
|
see
E-Z! _________________ HUMAN BUILT = HUMAN FIXED
CERTIFIED MARINE/PWC TECHNICIAN
www.switchbait.com |
|
| Back to top |
|
 |
JUST-IN-TIME Soul Rider

Joined: 24 Dec 2007 Posts: 356 City: ON YOUR BOAT
|
Posted: Aug 11, 2008 1:25 pm Post subject: |
|
|
see
E-Z! _________________ HUMAN BUILT = HUMAN FIXED
CERTIFIED MARINE/PWC TECHNICIAN
www.switchbait.com |
|
| Back to top |
|
 |
|
|
|