Posted: Jun 19, 2007 2:57 pm Post subject: heim joint adapters
I am going to build a tower and I need to find the threaded adapters that weld into the pipe.I have found tons of them for smaller pipes but nothing for 2 inch
I used a reducer too, picture from my earlier posting. Without the reducer it looked very rough. _________________ Opportunity is a bald man with a beard:
You can catch him coming, but you can' t catch him going.
where did you find the reducers at? I can only find the ones for threaded pipe and they look like crap. Also did you use another insert in there or did you just thread the insied to the size of youre heim?
I welded a piece of shaft inside the reducer. In the shaft I had threaded the size of my heim (M20 Fine-thread). I bought the reducer at my hardware supplier who also supplied the gaspipe, they normaly have fittings which are threaded (malleable fittings) or can be welded (weld fittings). I found a supplier on the net for you. My supllier would be a little to far away. Here's a link.
http://www.weldbend.com/Fittings/Concentric%20&%20Eccentric%20Reducers/stdconcecc.htm
Good luck constructing and building. _________________ Opportunity is a bald man with a beard:
You can catch him coming, but you can' t catch him going.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum
FAQ
Search
Memberlist
Stats
Favorites
Register
Profile
Log in to check your private messages
Log in
