Posted: Apr 15, 2006 7:11 am Post subject: Ballast Puppy Problem
I have a ballast puppy installed and very often I am not able to either drain or fill, ie. it only pumps one way unless I remove the impeller and then spin the pump the other way before putting the impeller back on. Loosening the screws on the impeller housing sometimes helps. Any suggestions?
There are about 20 threads on this same subject. Check out the search feature for ballast puppy.
However, as a quick bit of advice. Lube the crap out of the impellar. Also, make sure you have enough juice going to the pumps. If you don't they get stuck. Run one at a time. They are POS's in my opinion. I had them on my last boat and had nothing but problems with them. I would replace them with simmers if I were you. A little tap on the side of them when rocking the switches back and forth often dislodged mine.
Good luck. _________________ (insert funny chit here)
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum