Couple of questions.....

mizzouLF · Newbie Joined: 01 Jan 2004 Posts: 2 City: Ozark

Just got some LF Ultra bindings.

1) The hardware to attach them to the board....obviously the red washer type thing goes right under the head of the screw, then there's this plastic looking washer thing...does it go between the red metal washer and the binding? I'm assuming it does....

2) How do you tighten the overlay on this binding if its possible? I tried them on and they fit almost perfect except my heels felt a tiny bit loose. Thought I might have to tighten them if they loosen up from use.

Sorry for the newbie questions....I had a different type of binding last year. Happy New Years to everyone.

vette74 · Posted: Jan 05, 2004 5:48 am Post subject:

If you look at the bottom of the bindings you will see about 4-6 screws in the back and they will take off the white plastic pieces that hold the wraps down, adjust as needed they put them right in the middle.
Word of caution it is difficult to get them put back together by yourself you really need three hands or a lot of patience.

pooser · Wakeboarder.com Freak Joined: 13 Jan 2003 Posts: 4738

wakeskatehead45 · Newbie Joined: 09 Jan 2004 Posts: 6 City: wellington

usually in all boots they are loose in the back u just have to get used to the boots and how it rides thats all

Sportster4Tec · Posted: Jan 15, 2004 5:26 pm Post subject:

Anyone have trouble with the white rubber overlays getting in the gay of screwing the screws in? It kinda annoys me that they stick out so far that you can really put the screws in the inside holes.

NoTalent73 · Criminal Joined: 16 Sep 2003 Posts: 57

plastic thing under washer